This page is for Product information and Technical Support

Installation hints are included with information on the Product Pages

Anchors   Start Blocks   Tensioner    Wire Clamp

Lane and Deck Anchors

All Lane and Deck Anchor installation hints here

Top

Start Blocks...

Start Block Installation Instructions here (PDF)
Top

Super Tensioner

ALL LANES ON SS WIRE use fine (7 x 7)  3mm diamter SS wire,
with proven > 700 KG breaking strain.

Scroll down for Tensioner Assembly, Clamp Parts and Assembly 

Download Fitting and Adjustment Instructions  (PDF)  684 kb   End Cap + Barrel (Body) + Booker Rod (Threaded rod with S hook)

	SUPER TENSIONER Stainless Steel & composite plastic construction provides simple fuss free tensioning of stainless steel wire lane. NO OPEN TEETH OR RATCHET! (Open Ratchet tensioner now Illegal in NZ due to possible trapping of little fingers and toes)
Parts Available for Tensioners: End Cap (Left Hand Thread) Barrel/Body (with integrated brass nut) Booker (threaded) Rod with 'S' Hook Lock Nut

Anti Wave Super Tensioner:

• Is easy to adjust 
• Will NOT fray cable 
• Will NOT need a ratchet wrench  to drop into pool
  
• Is good value for the money 
• Doesn't need constant adjustment 
• Has NO ratchet mechanism 
• Comes with a 3 Year Warranty
• Looks good! 
• Will fit any manufacturer's lanes 
• Has no internal components to break or corrode 
• Is easy to use with existing lanes 
• Can't be accidentally released

Wire Clamps

S Hook and Clamp (non tensioner end)

and here it is assembled with cap, dome nuts & bolts.....

Place a washer on wire first to protect lane discs...
 

Wire Clamp only (fits inside Tensioner Cap)
see Cable Retainer above...

Assembly of Wire Clamp: This is the old version "Short Clamp"...
 

	Wire Clamp parts and assembled as below. Easy! Wire is fed in at left hand end (above pic) and looped around machine screws. Place Flat bar over screws and wire, then secure with washers and Dome Nuts.

This is the latest version "Short Clamp"... features integral pressed in studs. Makes assembly easier:

Top and underside of clamp cup showing pressed-in studs:

With plate that locks wire...

Assembly of new version Wire Clamp:

	1) Loop wire around studs (use pliers to form loop if required)
	2) Place plate over studs
	3) Place supplied washers and nuts on studs Tighten fully (Re-check tightness after approx 1 week)